Top Application
Where JALE parts actually go to work — matched to the machine, the material and the job. Each application below links to the parts it uses.
Excavator Bucket Pins for Construction Site Earthmoving
Worn pins let the bucket rock, which cracks the ears and destroys the bushing fit. Hardened, ground-finish pins hold the linkage tight.
Bucket Bushings for High-Cycle Digging
The bushing wears before the pin does. A matched pin-and-bushing set restores the joint and costs far less than a new linkage.
Bucket Teeth for Rock and Trenching
Tooth shape decides how the bucket cuts. Chisel teeth for rock, flatter profiles for trenching and grading.
Cutting Edges for Loader and Excavator Buckets
The cutting edge is the wear surface that protects the bucket floor. Bolt-on and weld-on profiles for standard and heavy-duty work.
Track Chains for Undercarriage Rebuilds
Track chain, rollers and idlers wear as a set. Replacing one component alone usually shortens the life of the others.
Track and Carrier Rollers for High-Hour Machines
Rollers take the full weight of the machine. Seized or flat-spotted rollers load the chain and accelerate rail wear.
Plow Bolts and Track Shoe Nuts for Undercarriage Service
Correct grade and thread pitch matter — a soft bolt stretches and the shoe works loose. Supplied as matched bolt-and-nut sets.
Swing Gearbox Bearings for Slewing Repairs
Swing gearbox failures are usually bearing failures. Correct internal clearance and fit are what make the repair last.
Travel Motor Bearings for Final Drive Overhauls
Travel motor and gearbox bearings carry the machine's drive load. Replaced during final drive rebuilds.
Swing Motor Bearings for Rotation Assemblies
Swing motor bearings control play in the rotation assembly. Excess play shows up as drift and brake wear.
Bucket Linkages and H-Links for Loader Arms
Linkage pins, bushings and links transfer the whole digging force. Wear here shows as slop in the bucket before anything else fails.
Excavator Buckets for Earthmoving and Rock
General-purpose, heavy-duty and rock buckets built to the machine's pin-on dimensions and linkage geometry.
Round Steel Bar for Machined Pin Production
The raw stock the pins are cut from — consistent grade and diameter, which is what makes a batch of pins behave identically.
Heavy Equipment Shovels for Loading Applications
Ground-engaging tools and shovel components for loaders and heavy equipment working abrasive material.
Mini Excavator Parts for Compact Machine Fleets
Compact machines run tighter tolerances and higher cycle counts on small parts. Pins, bushings and teeth to mini-excavator dimensions.
Precision Washers and Stamped Parts for OEM Assembly
Machined and stamped components made to drawing — the same production that makes the pins, applied to assembly hardware.